Universal Microphone Shock Mount, Mic Clip Holder for 47-53mm Mics, Anti-Vibration, High Isolation

Holds my Behringer C-1 microphone snugly. It's got a good build quality, and keeps the microphone held under good, strong tension. It's all black, and sleek with a smooth finish. It absorbs vibrations like a champ, and is fantastic value for the money.I'd definitely buy this again.

This paired with a Gator Frameworks Ball/Socket Adapter, made for good support and adjustment on my boom arm. Almost had to tighten the arm with vice grips, because of the RE320 weight, but as far as the mount itself it fit exceptionally well for my application. I didn't want to overspend on a mount nor use a large clunky one either. Just wanted to keep it as minimal as possible and this one worked aces. Nice that it comes with 2 spare rubber bands.

A must have if you have a rode NT mic and you’re tired of the one that they included because the shock arm is just so heavy this one pretty much almost a quarter of the weight and it makes it so that your mic arm doesn’t start sinking down. Does the job pretty well too highly recommend that you also buy a pot filter that can attach that at that point you’re pretty much set.

I run an RE-20 on a rigid desk mounted El Gato boom arm, the factory hard mount transferred quite a bit of desk vibration into the mic. This shock mount attenuates it a good bit and it's a lot lower profile than the EV mount that is truly meant to be suspended in the air. I prefer having the mic mostly out of frame and below my face for business use.It is not a miracle cure but it helps and the price is right. Build is solid on it as well.

I am running the Elgato wave low profile setup. It is a spectacular combination. The mic fits right in and stays on the arm. The knuckle is strong and the mic does not droop down. I did not even have to adjust extra pressure to the gas arm to hold the weight of the mic and the mic and the shock mount. I needed to have the room to be able to type and move around the desk without desk and vibration noise. I was going to go with the Electro Voice shock mount but it is over 100 and so large that it would impact the space when I turn the arm around while not in use.I highly recommend this shock mount because it fits easily and absorbs all the vibrations from the desk.

i wanted an alternative shock mount for my re320, this delivered, it is quite low profile, holds the mic steady, would buy again

Holds my microphone sturdily and eliminates the vibration from the table. Must have for anyone using an external mic. Great value

This is 42-45mm! Again!! I am tired of buying false advertized larger mounts and getting this junk. Over and over again!!Sellers! It is likely not your fault but some stupid leging manufacturers who mislabel their products. So MEASURE the openings before putting your batch on sale!!