15Pcs 4.5" x 7/8" Nylon Fiber Flap Disc Polishing Grinding Wheel,Scouring pad Buffing Wheel for Angle Grinder

worked, better than anticipated

I used on my 4½ grinder to clean a tub that had serious hard water calcium build up. This was alittle over kill for that application but planned on repainting and sealing the tub. These worked great and really stood up. After a good hour of working with the highest grit I compared to a new one and it only showed about ⅙ to ⅛ inch of wear. I also use the softest grit with little pressure to scuf for the paint coat. Worked awesome.

I'm not quite sure what these are for. They don't remove mill scale, they don't polish steel, they take away any shine from steel. 3 stars because they fit on my grinder and I have a lot of them .Maybe I'll find a use for them. I would not purchase again. They are delicate at 10k rpm

These are actually 4.5", whereas some others that I have found are slightly undersized. Don't buy from another seller to save a few measly cents per unit. These are a good deal!I used these (red) for taking corrosion and clear coat off of aluminum wheels. I was very impressed with them, the only complaint that I have being they tear easily. If you have to work around sharp edges, like a hole in a wheel, either work with an abundance of caution or expect it to take them down pretty fast.This is just a part of the design - they are soft and flexible to conform but that inherently means that they do not hold up well to ripping forces.The backing material is relatively soft, it is not a grinding disc like it looks. I would not advise scraping the back on parts to be cleaned up if they are aluminum or softer, but an accidental bit won't cause much harm. If you need to take it down to expose more pad edge, I found I could run the backside against something hard and wear out some of that until the pad was exposed again.They also work very well to remove rust, paint and more from automotive bodywork. They are fast!Softer materials like aluminum will be satin finish when done, and show some very light but consistent scratches throughout. Nothing deep, and easily polished out later with a proper buff pad and product.

Melts instantly when you touch it to metal.Not what I was expecting. Once melted, it's difficult to remove.Can not use at all. What I should have ordered is something called a (Interleaf Flap Wheel )Why did you pick this product vs others?:It's cheaper but still not useful for anything.Polishing ability:noneDurability:melts instantly

WORKS GREAT TO REMOVE OXIDATION ON REALLY OLD EPDM RUBBER ROOF. LASTS FOR 100'S FT. SCRUBBING BEFORE APPLYING PRIMER AND PEEL AND STICK FLASHING OR SPLICE TAPE. IF YOU CAN SCRATCH THE RUBBER OFF UNDER YOUR FINGERNAIL IT IS ANCIENT EPDM, BUT THIS GETS 30 MINUTES OF SCRUBBING DONE IN A MINUTE OR 2."""""VARIABLE SPEED GRINDER REQUIRED FOR EPDM ROOF""""

Exactly as described

Makes scuffing up old paint easy, and stripping other finishes